Copier User Manual
Table Of Contents
- Introduction
- Control Panel and Configuration Menu
- Sending Faxes
- Basic Fax Operation
- Adjusting the Image Quality
- Specifying a Recipient
- Specifying Multiple Recipients
- Sending a Fax at a Specified Time (Timer Transmission)
- Sending a Batch Transmission
- Memory Transmission and Direct Transmission
- Sending a Fax Manually
- Sending a Fax to a Combination of Fax Numbers (Chain Dial)
- Canceling a Queued Transmission
- About the Fax Header
- Faxing From a Computer (PC-FAX)
- Receiving Faxes
- Registering Recipients
- Confirmation Mode
- Troubleshooting
- Appendix
59 Sending Faxes
About the Fax Header
If transmission source information is set in Header setting to be printed, informa-
tion such as the sender’s name, fax number, transmission date/time, session
number and page number can be printed by the recipient.
The following items are in the header.
" To print the header, specify the transmission source settings with ADMIN.
MANAGEMENT/USER SETTING in the UTILITY menu, and then set FAX
TX OPERATION/HEADER to ON. For details refer to “FAX TX OPERA-
TION” on page 30.
Element Description
Transmission date/time Shows the date/time that the fax was sent. The
time is indicated in the 24-hour format.
Fax number Shows the sender’s fax number.
Sender’s name Shows the sender’s name.
Session number Shows the session number used to manage the
sent fax.
Page number Shows the page number.
Shown as page number/total number of pages.
" With a transmission using the telephone or
the On hook key or with a direct transmis-
sion, multiple pages are not shown.