Copier User Manual
Table Of Contents
- Introduction
- Control Panel and Configuration Menu
- Sending Faxes
- Basic Fax Operation
- Adjusting the Image Quality
- Specifying a Recipient
- Specifying Multiple Recipients
- Sending a Fax at a Specified Time (Timer Transmission)
- Sending a Batch Transmission
- Memory Transmission and Direct Transmission
- Sending a Fax Manually
- Sending a Fax to a Combination of Fax Numbers (Chain Dial)
- Canceling a Queued Transmission
- About the Fax Header
- Faxing From a Computer (PC-FAX)
- Receiving Faxes
- Registering Recipients
- Confirmation Mode
- Troubleshooting
- Appendix
77 Registering Recipients
7 Press the Back key.
" To delete another destination, repeat the procedure from step 5.
8 Press the or key to select FINISH, and then press the Enter key.
The destination is deleted from the favorite list.
" To return to the Fax mode screen, continue pressing the Back key until
the Fax mode screen appears, or press the Stop/Reset key.
Speed Dialing
Registering a Speed Dial Destination
Frequently specified fax numbers (maximum of 220) can be registered as speed
dial destinations. In addition, batch transmission settings can be specified.
1 Press the or key to select UTILITY, and then press the Enter key.
" For details on selecting a menu, refer to “General Procedure for Specify-
ing Settings in the Utility Menu” on page 36.
2 Press the or key to select DIAL REGISTER, and then press the Enter
key.
3 Press the or key to select SPEED DIAL, and then press the Enter key.
The SPEED DIAL screen appears.
4 Use the keypad to type in the speed dial number (1-220), and then press the
Enter key.
" If LDAP search settings have been specified, a screen allowing MANUAL
SETTING or LDAP SEARCH to be selected appears after the Enter key is
pressed. Select MANUAL SETTING, and then press the Enter key.
" For details on entering/editing numbers, refer to “Entering Text” on
page 97.
" If the destination is already registered with the specified speed dial num-
ber, REGISTERED! appears. Press the Back key to return to the DIAL
REGISTER screen, and then continue with step 3.
5 Enter the name of the speed dial destination to be registered, and then press
the Enter key.
" Text up to 20 characters long can be entered for the name.
" For details on entering/editing text and the characters that can be
entered, refer to “Entering Text” on page 97.