Operation Manual

Formatting Features
Variable line feed
I Line feed
Decimal
Hex. ASCII Comp.
I Re,·cr~L·linc iecd n = 0 to 2:;:; 27 106 n lB 6A n FSCj n F
The reverse line feed command enables you to set a fine reverse LF
of n /2 16 inches to your own requirements. This command is
carried
out only once so if you want to skip back a few times you
will have to send the command once for each back-skip required.
It is not possible to
reverse back over the Top Of Form.
We
do not recommend that you use this command if you have the
normal tractor feed unit fitted.
Absolute and relative dot positioning
Dot positioning Decimal Hex. ASCII Comp.
Absolute dot positioning
27 36
nl n2 lB 24 nl n2 ESC S n1 n2
F
RelatiYe dot positioning 27 92 nl n2 lB SC nl n2 ESC\ nl n2 F
The absolute dot position code sets the next printing position by
counting in 1 I 60 inch dot units from the left margin.
nl is decimal number between 0 and 255; n2 is a decimal number
between 0 and 3.
5- 14 Epso11 FX Mode Sta11dard Features