Operation Manual

ManualsBrandsOki ManualsPrinterML3410

The following options are

used

when

the parallel interface is

selected.

1-Prime: Buffer

print-

when

this signal is received, the

printer

is initialised after the buffer

data

is printed. Buffer clear

-the

printer is initialised after the current line has been printed.

Invalid-

This signal is ignored.

Pin

18: This

pin

supplies

SV

or

zero volts

as

required

by

external

device

when

connected

to

interface.

Auto

Feed

XT:

There is normally

no

Line Feed after a Carriage

Return if the Auto Line Feed is set to

NO. However, in the Epson

emulation, if the Auto Line Feed is set to

NO

and

the

Auto

Feed

XT

is

set

to

valid, a Line Feed is executed

upon

an

Auto

Feed signal

on

pin

14

of the parallel interface. This exception

may

be

necessary for

some

hardware/software

combinations.

The following options are

used

only

if the serial interface is

selected (see

Appendix

C for details).

Parity: Selects parity.

Serial

Data

7-

or

8- Bits: Selects

data

format.

When

the Serial Data

7-

or

8- Bits is

set

to

7,

the Parity

must

be

set

to either ODD

or

EVEN.

7-

Bit Serial Data will

not

be

printed

correctly

if

the Parity

is

set

to NONE. ·

Protocol:

Selects interface protocol.

Diagnostic Test: Activates the

printer's

interface diagnostic test.

Busy Line: Selects line used for

busy

signal.

Baud

Rate: Selects

data

transmission speed.

2-

16

Operation