Operation Manual

The default values for the right margin (n2) are as follows:
CPI
10 12 15 17.1 20
r-
136 163 204 233 272
'---
If n1, n2, and n2-n1 are outside the range, the entire command is
ignored
and the left and right margins remain unchanged. The n1
and n2 values indicate left and right margins of the printable area.
Example
When n 1 10 and n2 = 100, the print area is from column 10 to 100
with 91 printable columns.
The default value for the left margin is fixed at 1.
When the command is entered at the beginning of a line, it takes
effect from that line.
When it is entered in the middle of a line, it
takes effect from the next line.
Automatic carriage return in word units as in IBM color printer is
not performed.
Note: Word unit automatic carriage return means that when the right margin is
exceeded, the last word is printed on the next line instead of being split at the end
of a line This is used with word processors.
Horizontal tabs
When you turn on the printer, tabs are set automatically for every
eighth character. As with a typewriter, however, you can set your
own horizontal tab stops on the ML3410. You set the stops with a
line
at the beginning of your program, and insert an HT code
whenever you want to skip to the next tab stop. Some important
distinctions will give you more flexibility.
You can set up to 28 tab stops in either IBM mode or up to 32 in
Epson mode but you must enter them in left-to-right sequence or
in ascending numeric order.
3-22 IBM Modes Standard Features