Operation Manual

Operator Panel
-27-
Setup
1
Entering Text Using the
Operator Panel
When you need to enter text while setting an
item, the entry screen shown below appears.
You can enter upper and lower case letters,
numbers and symbols with the screen keyboard.
Memo
 When you need to enter only numbers, the screen
keyboard may not appear. In this case, enter numbers
using the ten-key pad.
Entering Text
1
Press , , , to select the character
you want, and then press .
The selected character is entered in the text field.
2 Repeat step 1 until all the characters
required are entered.
3 Press the and to select [Enter] and
press to complete the entry process.
 Using the Ten-key Pad
You can also use the ten-key pad to enter
alphanumeric characters and symbols in the
entry screen.
You can enter the numbers labeled on each key,
as well as the other characters by pressing the
keys repeatedly.
1 Press a key on the ten-key pad until the
character you want appears in the text
file.
2 Repeat step 1 until all the characters
required are entered.
If you continuously press the same key, you can
press the button to move the cursor.
3 Check that [Enter] is selected and press
to complete the entry process.
Memo
 You can enter the following characters by pressing the
keys on the ten-key pad.
OK
OK
Ten-key Characters
1 1
2 abc2ABC
3 def3DEF
4 ghi4GHI
5 jkl5JKL
6 mno6MNO
7 pqrs7PQRS
8 tuv8TUV
9 wxyz9WXYZ
0 (Space) 0
* @*
# ._-(Space)+!"$%&'(),/
:;<=>?[\]^#
OK