Operation Manual

Loading Paper and Documents
-37-
Setup
1
3 Press the to select the paper tray in
which you loaded paper and then press .
4 Press the to select [Custom] and then
press .
5 Enter the desired value using the ten-key
pad and then press .
Press the or to move to the next box.
6 Press the until the top screen is
displayed.
Paper Output
Your machine outputs to the facedown or faceup
stacker. Paper types that can be outputted to
each stacker are as follows.
When performing duplex printing, paper outputs
to the facedown stacker.
Note
 Do not open or close the faceup stacker while printing as it
may result in a paper jam.
 Using the Facedown Stacker
Delivers paper with the print side face down.
Note
 Check that the faceup stacker on the rear side of the
machine is closed. If the faceup stacker is open, paper is
always outputted to the faceup stacker.
 Using the Faceup Stacker
Delivers paper with the print side face up.
Note
 The faceup stacker is not available in duplex printing.
1 Pull the faceup stacker on the rear side
of the machine and open it toward you.
2 Unfold the faceup stacker.
Documents
You can use the auto document feeder (ADF) or
the document glass to load documents for
copying, scanning or faxing.
Document Requirements
You cannot load the following documents on the
ADF. Use the document glass instead:
 Torn or perforated paper
 Curled or rolled paper
 Wet paper
 Static paper
 Carbon-backed paper
 Fabrics, metallic sheets or Transparency films
 Paper with staples, paper clips, ribbons, or tape
 Pasted paper, paper with glue
 Glossy paper
 Specially coated paper
Output
Stacker
Supported
paper type
Paper output
capacity
Facedown  Standard
 Recycled
paper
 150 sheets (when
paper weight is less
than 80 g/m
2
)
OK
OK
OK