Operation Manual

Basic Procedure for Faxing

-87-

Faxing (for MB451, MB451w, MB471, MB471w, MB491, MB491+,

MB491+LP, ES4191 MFP, MPS4200mb, MPS4700mb only)

Note

 When you take a copy with the document glass, do not

apply an excessive load to the document glass.

Specifying a Destination

You can specify a destination in the following six

ways:

 Using the ten-key pad

 Using a speed dial

 Using a group

 Using the transmission histories

 Using the reception histories

 Using the one-touch key pad

Perform the following procedures at step 5 of

"Sending a Fax" P. 86 described above.

Direct Input

You can enter a destination fax number directly

by using the ten-key pad. You can enter up to 40

digits.

1 Press the to select [Direct Input] and

then press .

2 Enter a destination fax number using the

ten-key pad on the operator panel.

3 Select [Enter] and then press .

Memo

 You can use the ten-key pad to enter a destination also on

the screen that is displayed after pressing the <FAX/

HOOK> key. In this case, the fax start screen appears

after entering a destination.

 Dialing Functions

You can use the following functions when

entering a destination fax number.

Select the function you want and then press on

the fax number entry screen.

 -(Hyphen)

Inserts a hyphen to the entered fax number.

 PreFix

Inserts a prefix number registered in advance.

"N" is inserted when entering.

 Flash

Orders your PBX(Private Branch Exchange) to

connect you with PSTN(Public Switched

Telephone Network). When inputting, enter "F".