Extra Information

- 59 -
List of Setup Menu
2
2. Changing Printer Settings
Item Value
Factory
Default
Descriptions
System Adjust Low Toner Continue
Stop
* Sets printer operation
when Toner Low is
detected.
Jam Recovery On
Off
* Set whether JAM
RECOVERY printing is
performed or not when
Jam occurs.
Error Report On
Off *
Sets whether an error
report is printed or not
when an internal error
occurs.
Hex Dump Execute Prints out data
received from the host
PC in the hexadecimal
Dump. Turning off the
power supply switch
restored Normal Mode
from HEX Dump Mode.
Print Adjust Print
Position
Adjust
MPTray X Adjust 0.00millimeter
+0.25millimeter
―
+2.00millimeter
-2.00millimeter
―
-0.25millimeter
* For the paper fed from
MP Tray
Adjusts the position of
a whole print image
in the direction that is
perpendicular to the
direction paper runs,
that is horizontally (at
0.25 mm pitch).
Y Adjust 0.00millimeter
+0.25millimeter
―
+2.00millimeter
-2.00millimeter
―
-0.25millimeter
* For the paper fed from
MP Tray
Adjust the position of
a whole print image
in the direction paper
runs, that is vertically
(at 0.25mm pitch).
Print
Position
Adjust
MPTray Duplex X
Adjust
0.00millimeter
+0.25millimeter
―
+2.00millimeter
-2.00millimeter
―
-0.25millimeter
* For the paper fed from
MP Tray
At the time of back
page printing of
Duplex, adjusts
the position of the
whole print image in
the direction that is
perpendicular to the
direction paper runs,
that is horizontally (at
0.25mm pitch).
Duplex Y
Adjust
0.00millimeter
+0.25millimeter
―
+2.00millimeter
-2.00millimeter
―
-0.25millimeter
* For the paper fed from
MP Tray
At the time of back
page printing of
Duplex, adjusts the
position of a whole
print image in the
direction paper runs,
that is vertically (at
0.25mm pitch).