Printer User Manual

3 - 9
3.3.3 LED Head
(1) Open the stacker cover.
(2) Remove the flexible cable (LED) 1 from the PC connector 2 of the LED head 3.
(3) Remove the LED head by prying the left side free from the retaining clip.
Note: Be careful to not lose the contact (LED) 4.
Note: • Be sure not to directly touch or push the SLA part of the LED head.
• After mounting the new LED head, set drive time of the LED head according to the
marking on the LED head (see 4.3.1 or 4.3.2).
• For the installation of the flexible cable (LED) 1, install the PC connector 2 to the
flexible cable (LED) 1 first, then connect the LED head 3 to the PC connector.
• When installing a new LED head, be careful not to lose the contact (LED) 4.
3
SLA part
2
1
3
4
3
2
1
OKIPAGE 6ex
OKIPAGE 6e