Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 35
2.2 Local Functions
Note OEM Fiscal Type :
This section describes local maintenance capabilities under the control of the printer block.
The fiscal control PCB should be removed before the functions are performed.
2.2.1 Types
Local Functions
Local test
All letters & rolling ASCII continuous printing test (Receipt)
All letters & rolling ASCII continuous printing test (Journal)
All letters & rolling ASCII continuous printing test (Receipt+Journal)
All letters & rolling ASCII continuous printing test (Slip/Sprocket)
Sample data continuous printing test (Validation)
MICR read test (Receipt) (only with MICR Type)
Rewinder winding-performance evaluation continuous printing test (Journal)
Menu function (Receipt)
Hexadecimal dump (Receipt)
Platen maintenance mode