Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 45
2.7 Rewinder Winding Evaluation Continuous Print Test (Journal)
This function performs print/platen switch continuous test to evaluate the rewinder winding performance.
(1) How to start
Turn the power on while holding down SW3 + SW1 + SW4.
(2) How to exit
Turn the power off.
• During test printing, if you press SW1, printing suspends. If you press SW1 again, printing resumes.
(3) Contents printed
(a) Prints “HHH”+ Space + “HHH” (UTL characters)
(b) Print Sheet Mode switching (Journal Slip Journal)