Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
50
OKIPOS 425D
|
3.2 Replacing the Roll Paper
When the Roll is used up, load a new one, following the procedure shown below.
3.2.1 Roll Paper (Receipt)
1. Press Form Feed switch (1) on Receipt side so that the whole Receipt Paper (2) is ejected.
o425_62.jpg
2. Press the Cover Open Bar and open the Printer Cover.
* Caution! The printhead may be HOT!
o425_31.jpg and o425_32.jpg
3. Load new paper roll.
For loading Roll Paper, refer to Section 1.5.1.2.
2
1