Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 95
6. Command Description
6.1 Control Code List
6.1.1 OEM — Standard Model
6.1.1.1 Function Code
1 List of Function Codes
A25037.doc
No. HEX DEC CODE Remarks Print Start
1 0A 10 LF Print/line feed O
2 0C 12 FF Cut Sheet paper eject or sprocket paper form feed O
3 0D 13 CR Print/carriage return O
4 0F 15 SI To set condense X
5 12 18 DC2 To reset condense X
6 18 24 CAN Print data cancel X
7 1B 27 ESC ESC sequence start -
8 1D 29 GS GS sequence start -
91E 30 RS Journal Tab X
10 1F 31 US US sequence start -
* Print Start Column
O : Command that invokes print start
X : Command that does not invoke print start
^ : Command that sometimes invokes print start
This applies hereafter.