Operation Manual

Menu functions > 60
USB Setup
This menu controls the operation of the printer’s USB data interface.
When you have changed any settings in the USB menu, turn the printer OFF, then ON
again.
Storage setup
Power setup
Language setup
ITEM SETTINGS EXPLANATION
USB Enable / Disable ENABLES / DISABLES the USB port.
Speed 480 / 12 Mbps Selects the interface speed. After setting change the
menu, the printer restarts on exit.
Soft Reset Enable / Disable Enables or disables the SOFT RESET command.
Offline Receive Enable / Disable OFFLINE RECEIVE.
Serial Number Enable / Disable Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB device
connected to your PC.
ITEM SETTINGS EXPLANATION
Enable Initialization No
Yes
Prevents a setting change accompanying initialization of
BlockDeveice (FLASH).
ITEM SETTINGS EXPLANATION
Peak Power Control Normal
Low
Sets Peak Power Control level.
Sleep Enable
Disable
Sets Enable/Disable of Sleep Mode.
USB Host Power Off
On
Set power supply for USB-HOST of the whole power save
mode.
When Off, suppress power supply.
When On, do normal power supply.
ITEM SETTINGS EXPLANATION
Language Initialize Execute Initialises the message file loaded in FLASH.
When you press the Enter button, the following
message, requesting confirmation, will appear,
Are You Sure?
Yes
No
If NO is selected, you will be returned to the source
menu.
The procedure for clearing the disk will start immediately
after the menu and rebooting.