Extra Information

- 40 -
Changing the Equipment Settings
3
3. Changing Printer Settings
Admin Setup
Item Settings Explanation
Enter Password xxxxxxxxxxxx Enter a password to gain entry to the Admin
Setup menu.
Password should be from 6 to 12 digits
of alpha/numeric characters (or mix) The
default value is “999999”
Network Setup Enabling Default Gateway Wired
Wireless(Infrastructure)
When a wireless LAN is available, set a valid
default gateway.
Wired Enable
Disable
Enables/Disables the wired LAN.
TCP/IP Enable
Disable
Sets TCP/IP Protocol.
[Enable]: TCP/IP Protocol is available.
[Disable]: TCP/IP Protocol is not available.
NetBIOS over TCP Enable
Disable
Sets enable/disable of NetBIOS over TCP protocol.
Display Conditions:
● TCP/IP should be enabled.
IP Address Set Auto
Manual
Sets the IP Address setting method.
Display Conditions:
● TCP/IP should be enabled.
IPv4 Address xxx.xxx.xxx.xxx Sets the IP Address.
Display Conditions:
● TCP/IP should be enabled.
Subnet Mask xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions:
● TCP/IP should be enabled.
Gateway Address xxx.xxx.xxx.xxx Sets the Gateway (default router) address.
0.0.0.0 means that there is no router.
Display Conditions:
● TCP/IP should be enabled.
DHCPv6 Enable
Disable
Sets enable/disable of DHCPv6.
Web Enable
Disable
Sets enable/disable of Web.
[Enable]: Web/IPP is available.
[Disable]: Web/IPP is not available.
Display Condition: TCP/IP should be enabled.
Telnet Enable
Disable
Sets enable/disable of Telnet.
[Enable]: Telnet is available.
[Disable]: Telnet is not available.
Display Condition: TCP/IP should be enabled.
FTP Enable
Disable
Sets enable/disable of FTP.
[Enable]: FTP is available.
[Disable]: FTP is not available.
Display Condition: TCP/IP should be enabled.
IPSec (if enabled) Enable
Disable
Sets enable/disable of IPSec. Enable via the web.
[Enable]: IPSec is available.
[Disable]: IPSec is not available.
SNMP Enable
Disable
Sets enable/disable of SNMP.
[Enable]: SNMP is available.
[Disable]: SNMP is not available.
Display Condition: TCP/IP or NetWare should
be enabled.
Network Scale Normal
Small
When [Normal] is selected, the network can
work effectively even when it is connected
to a HUB that has a spanning tree feature.
However, printer start up time gets longer
when computers are connected with two or
three small LANs.
When [Small] is selected, computers can
cover from two or three small LANs to a
large LAN, but may not work effectively
when the network is connected to a HUB
with a spanning tree feature.