User's Manual

OKIN Refined Electric Technology Co.,Ltd
Page 4 of 5
Step 3: Two seconds later connect again the DC plug of the control box to the SMPS to turn on
the power.
Step 4: Press simultaneously and hold the head up button
and feet up button on the
handset until backlight LED flashing. Release the two buttons and LEDs continue flashing and
search with control box, once the LEDs stop flashing the matching is successful, which means
the control box and the handset can work together.
All matching set up process must finish in two minutes after turning on again the power of the
control box.
Configuring two beds to a big bed
Connect the two control boxes with the cable as below, as do this, the two beds can work
synchronously.
Usage notice of the Control Box
1. The control box is designed for using the SMPS of 29VDC/ around 2A as the power. It is
necessary to use the SMPS provided by us when normal operation.
2. In the case of the AC power utility failure, the battery box for backup of 18VDC can be used
as the power. It is only for flatting the bed plate without load if the battery box used as the
power and each one of the batteries must be new with 9V voltage. Due to the electric
quantity of the batteries limit it is impossible to move repeatedly the bed plate, it is strongly
recommended to use in turn the button “Head Down” and “Feet Down” to drive the head
motor and feet motor in turn not simultaneously to flat the bed plate. Not to use the button
“Flat” to flat the bed plate, in this way the battery voltage will be pulled down by the bigger
current because the head motor and the feet motor is driven simultaneously, that perhaps
results the motors will not work normally. It isn’t also strongly recommended to start the
massage motors when the battery box used as power.
FCC STATEMENT: FCC ID: PCU-JLDK-18-1
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.