User's Manual

OKIN Refined Electric Technology Co.,Ltd
Page 3 of 4
Step 5: Press and hold
up button and up button until backlight LED flashing. Loose
the two buttons and LED continue flashing and search with control box, once LED stop flashing
the matching is successful, which means the control box and the handset can work together.
All matching set up process must finish in 30sec after power on control box.
Notes：USB cable only use for synchronized operation of two beds.
4、Memory operation：
Z-G button can be set as a memory button by user.
Step 1: Adjust the head position and feet position until your like position;
Step 2: Press and hold the
button for 1sec, backlight LED start flashing;
Step 3: loose
button, during next 1sec, press button, LED stop flashing. Then
memory operation is successful.
FCC STATEMENT: FCC ID:PCU-JLDK.18
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.