User's Manual

嘉兴礼海电气科技有限公司
OKIN Refined Electric Technology Co.,Ltd
Page 21 of 23
Wireless pairing operation
Step1: Push the DIP Switch on the remote control to a certain position（different from the
position on the other remote controls paired with the near other control boxes. ） and put in the
batteries.
Step2: Power on the control box.
Step3: Press and hold the pairing Tact Switch on the control box with the pairing LED turning on
until the pairing LED on the control box turns off ;then release the Tact Switch and the pairing
Led begins flashing that indicates the control box is pending to pair.
Step4: Press and hold simultaneously the Head-Up button and the Foot-Up button on the
remote control until backlight LED flashing. Release the two buttons and the backlight LED
continue flashing and search the control box pending to pair where the pairing Led is flashing,
once both the backlight on the remote control and the pairing Led on the control stop flashing,
the pairing operating is completed. To test if the pairing successfully, press the Head-up or
Head-down or Foot-up or Foot-down button，as so on, related to the actuators , if the click sound
from the relays in the control box can be heard that means it is successful. Otherwise, repeat
the all above steps.
It is strongly recommended that the near control boxes, for example, in a same house, should
be configured differently. Each control box must be paired with the different remote control
where the DIP-Switch position is deferent. Doesn’t pair both control boxes with the same
remote control or the different one but in which the DIP-switch position is same.
Configuring for synch
Connect the two control boxes with the cable as below, the two control systems can work
synchronously.
It is important that the two control boxes expected to work synchronously must be still
configured differently to pair with the different remote control with different DIP-Switch position.
Doesn’t pair both control boxes with the same remote control or the different one but in which
the DIP-switch position is same.
Connect to the Control Box