OKIN IN Refi fined Electr E tric Te Techno nology y C , Ltdd Co.
OKIN IN Refi fined Electr E tric Te Techno nology y C , Ltdd Co. JLDK.42.18.01 JLDK.42.18.02 JLDK.42.18.03 JLDK.42.18.04 Page 2 off 6 JLDK.42.18.
OKIN Refined Electric Technology Co., Ltd 2、Button n descriptio on ctuator will go up. Sttop e button, th he Head ac HEAD UP button：Press and hold the A. when n released.. uator will go down. Sttop d hold the button, the e Head actu HEAD DN button：Press and B. when n released.. ctuator willl go up. Sttop nd hold the e button, the Foot ac FOOT UP button：Press an C. when n released.. D. FOOT DN button：Press and hold the button, the Foot actuator will go down. Stop when released. E.
OKIN Refined Electric Technology Co., Ltd K. FLAT button: Click the button, the Head and Foot actuator will start up and keep running until arriving to the FLAT position. Running can be stopped by clicking any button. L. UNDERLIGHT button：Click the button, the Under-light under the bed will turn on if it is being off or turn off if it is being on. If the Under-light is turning on as the button pressed, it will keep on for 5 minutes then turn off automatically if the button isn’t pressed again. M.
OKIN Refined Electric Technology Co., Ltd This LED flash a time, the vibrating time is 10minutes; This LED flash a time, the vibrating time is 20minutes; This LED flash a time, the vibrating time is 30minutes; S. Click this button to enter Wave mode: Head vibration (3 strength) , foot stop for 5 seconds, then the head stop, foot vibration (3 strength) for 5 seconds, repeat the above cycle until the end of time, all closed; The blue LEDs for backlight are on as long as any button is pressed.
OKIN Refined Electric Technology Co., Ltd FCC NOTE： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
