User's Manual

OKIN Refined Electric Technology
Co.
, Ltd
Page 5 of 6
always on as long as the power on.
The below positions can be changed or set by the end user.
The Zero gravity position;
The Memory A position;
The Memory B position;
The procedure to set these special positions is below:
Step 1: Click the button to flat the bed;
Ste
p 2: Adjust the Head and Foot position to a desired position by pressing the
button or or or ;
Step 3: Press and hold the button for 3sec, backlight LED start flashing;
Step 4: Release the button then click one of or or
button before LED stop flashing. Then the Flashing stops immediately to indicate
the corresponding operating has completed successfully.
and and can be restored to default sets by pressing and
holding the button for approximate six seconds until the backlight LEDs
finally stop flashing from first flashing.
This LED flash a time, the vibrating time is 10minutes;
This LED flash a time, the vibrating time is 20minutes;
This LED flash a time, the vibrating time is 30minutes;
S. Click this button to enter Wave mode:
Head vibration (3 strength) , foot stop for 5 seconds, then the head stop, foot vibration (3
strength) for 5 seconds, repeat the above cycle until the end of time, all closed;
The blue LEDs for backlight are on as long as any button is pressed. IF all buttons are
released the LEDs will automatically turn off three seconds later. The blue LED for power is