Quick-Start Guide

ManualsBrandsOklahoma Sound ManualsAudio Visual PresentationFull Floor Lectern #222

OKLAHOMA SOUND CORPORATION

Full Floor Lectern

ASSEMBLY MANUAL

MODEL #222

OPTIONAL EQUIPMENT

Additional Units (sold separately)

OKLAHOMA SOUND CORP.

149 Entin Road, Clifton, NJ 07014

el: 973-594-9000• Fax: 973-594-9339

e-mail: info@oklahomasound.com

eb-Site www

.oklahomasound.com

MODEL #22

TABLE TOP LECTERN

This versatile, portable

table top lectern, can

be used on its own or

as a floor lectern with

the optional base (sold separately).

5/8" stain and scratch resistance

thermofused melamine laminate on

MDF. Paper/book stop included.

Dimensions: 23

⁄4" W x 13

⁄4" H x 19

⁄8"D.

BRASS READING LAMP / #BRL

Attach an elegant brushed brass read-

ing lamp to the reading table of your

new Speaker Stand. Not only will you

shed light on the subject, but you will

add pizzaz to your new stand.

Available Color Options

Medium Oak • Light Oak • Mahogany • Walnut

MODEL #112

LECTERN BASE-AV CART

Converts your TABLE TOP Lectern

to a FULL FLOOR Lectern or use

as an AV cart for your presentation

equipment. Includes shelf and four

easy roll castors, with two locking.

Dimensions: 21

⁄8" W x 33

⁄4" H x 17

⁄2" D

Summary of content (4 pages)

PAGE 1
OKLAHOMA SOUND CORPORATION OPTIONAL EQUIPMENT Additional Units (sold separately) Full Floor Lectern ASSEMBLY MANUAL MODEL #22 TABLE TOP LECTERN This versatile, portable table top lectern, can be used on its own or as a floor lectern with the optional base (sold separately). 5/8" stain and scratch resistance thermofused melamine laminate on MDF. Paper/book stop included. Dimensions: 233⁄4" W x 133⁄4" H x 197⁄8"D.
PAGE 2
OKLAHOMA SOUND CORPORATION FULL FLOOR LECTERN: Model 222 INTRODUCTION 5) Once again go over all the cams and check to make sure the lectern is sturdy. The model 222 full floor lectern is attractive and durable: this full floor lectern is made of 3/4" stain and scratch resistant thermofused melamine laminate on flakeboard. Full sized reading surface, shelf and paper/book stop built in. Floor glides provided.
PAGE 3
OKLAHOMA SOUND CORPORATION FULL FLOOR LECTERN: Model 222 3) Now apply the left side panel to the semi assembled unit. Be sure to align the cam bolts to the holes on both the front panel and the shelf. Tighten cams (diagram “D”). ASSEMBLY INSTRUCTIONS Assembly Tips • Do not use a sharp instrument such as a knife or screwdriver to open the packaging, as this may scratch or damage the unit. • All assembly should be done on a clean protected surface such as carpet or the like.
PAGE 4
OKLAHOMA SOUND CORPORATION FULL FLOOR LECTERN: Model 222 INSTALLATION OF HARDWARE ASSEMBLY OF LECTERN 1) Lay out the wood panels as shown in diagram “A” (make sure the factory drilled holes are facing upwards).You can determine the top of the front panel by identifying the edge cut on an angle. It is important that the instructions on the assembly are followed carefully 2) Identify the holes numbered "1" in Diagram A. Screw the bolts into the holes with the #2 Phillips head screwdriver.