Owner Manual

Oklahoma Sound

FULL FLOOR LECTERN: Model 222

4 5

INSTALLATION OF HARDWARE

1) Lay out the wood panels as shown in Diagram A (make

sure the factory drilled holes are facing upwards). You

can determine the top of the front panel by identifying

the edge cut on an angle.

2) Identify the holes numbered "1" in Diagram A. Screw

the bolts into the inserts with the #2 Phillips head

screwdriver. Be sure to tighten the screws all the way.

BE CAREFUL NOT TO OVER-TIGHTEN THE BOLTS AS THIS

WILL STRIP THE WOOD!

3) The cams should be inserted in the larger holes as

shown on diagram. MAKE SURE THE ARROW ON THE

CAM IS POINTING TO THE CLOSEST EDGE AND ALIGNED

WITH THE HOLE ON THE EDGE.

4) Using a hammer gently tap plastic glides into bottom

edge as shown below (Diagram A). GLIDES SHOULD BE

INSTALLED NO FURTHER THAN ONE INCH FROM END.

Angle Cut Edge

Optional Casters

Mounting Holes

Optional Casters

Mounting Holes

Diagram "A"

ASSEMBLY OF LECTERN

It is important that the instructions on the assembly are

followed carefully

1) The rst piece of equipment that will be installed will

be the shelf Panel E. Make sure the cams face the bot-

tom of the lectern. The two bolts in the center of the

right hand panel A will align with the two holes on the

edge of the shelf (these holes reach until the cams)

gently push the shelf down on to the cam bolts until

the shelf is completely on the Panel A. Tighten the

cams by turning clock-wise until locked. (Diagram B)

2) Align holes on the edge of Panel B with three cam bolts

on the side of back Panel A, tighten cams. (Diagram C)

Diagram "B"

Diagram "C"