Installation Guide

Apply modied thin-set adhesive
or mastic to substrate using a
1/4” x 3/8” notch trowel.
(Aplique el adhesivo de capa
delgada modicado o masilla de
sustrato utilizando un 1/4" x 3/8"
llana dentada)
*Prior to installation, verify all
materials meet local building
codes and requirements.
For additional installation tips,
check with your local building
professional.
Store Brickweb between 55˚ & 95˚F.
Begin layout process by
applying Brickweb corners.
Firmly press Brickweb into
adhesive, ensuring adhesive
extrudes through webbing.
(Comienza proceso de diseño
mediante la aplicación de
esquinas Brickweb. Presione
rmemente el Brickweb en el
adhesivo, asegurando que salga
el adhesivo a través de la malla)
Apply Brickweb sheets by overlapping
exposed webbing. Firmly press Brickweb
into adhesive, ensuring adhesive extrudes
through webbing.
(Aplicar hojas Brickweb colocando sobre
malla expuesta. Presione rmemente el
Brickweb en el adhesivo, asegurando que
salga el adhesivo a través de la malla)
WARNING: The dust generated
from dry sawing may contain silica
and can be a potential health risk
to the lungs. Wet sawing is
recommended. Wear all necessary
protective equipment.
Apply grout using bag or oat.
(Aplicar el grout usando una
ota para piso de ceramic)
*To help keep brick faces clean, apply a
grout sealer or release product to the brick
prior to grout application.
1-888-264-6455
Old Mill Brick, Inc.
Finish grout with sponge.
(Terminar el grout con una
esponja humeda)
Apply Mortar using grout bag.
(Aplique el mortero con la bolsa)
Finish joint with tool.
(Termine el grout con
la herramienta)
(Recommended)
Patent Pending Product
Type-S mortar is recommended for lling mortar joints and will
provide a traditional look. Tile grout may be used if a dierent
color is desired and recommended on oors.
IMPORTANT: Mortar or grout must be removed from the brick
surface before drying. Rinse and rell bucket often with clean
water. Wipe until no residue rings from the sponge. Grout and
clean small sections at a time to avoid grout drying on brick.
Grouting or Pointing
If sheet slides down wall, place a few drywall
screws through webbing to hold in place.
Remove when adhesive is dry.
(Si la hoja se desliza por la pared, poner unos
cuantos tornillos para yeso a través de la malla.
Retirar cuando el adhesivo está seco)
Installation Instructions
Mortar Option
Grout Option
www.installbrickweb.com