Installation Guide

To determine the square footage of your project, simply multiply the length times the width. For example, if you are placing Old
Mill System on a wall that is eight-feet tall and ten-feet wide, the total square footage is 80 feet (8’ x 10’=80’). When you are taking
your measurements, remember to subtract areas that will not be covered by Old Mills System (Windows, Doors, Fireplaces etc.) from
the total square footage.
Note: Add 15% for waste.
Corners are sold by the lineal foot, which means you must calculate the total running feet of your project. Again, accurately calculating
this number is easy. For example, if you have an outside corner that measures twelve feet from the starting point to ending point, you
will need twelve lineal feet of brick corners. Panel that is ending within a wall will need corners or panel that is ending were the end of
the panel is showing it will also need corners.
Installation Guide for the Old Mill Thin Brick System