SPIN2000 INSTRUCTION MANUAL
WARNING Misuse of this machine may result in serious injury. Please read and follow all precautions below. This machine is not a toy and should not be operated by children. Take proper safety precautions when using this machine. Do not use the machine for other than its intended purpose and do not modify. Use only on grounded outlet and with a grounded 3-prong extension cord that meets or exceeds electrical rating. Do not immerse in water. Do not touch moving parts.
COTTON CANDY MACHINE & CART PARTS (PREINSTALLED)
FIRST-TIME SET UP PROCEDURE ! If your model includes a cart, please advance to page 7 to complete the cart assembly before proceeding. 1. Wipe the pan and floss head with a damp clean cloth and dry thoroughly. Do not clean with detergent or abrasive chemicals. 2. If you did not purchase the cart, place the cotton candy machine on a flat stable surface. The machine operates at very high speeds making stability essential. 3.
Safety Switch (not shown) Pan Bracket Fig. 1 Latch Fig. 2 4. Carefully, hold the pan on top of the base aligning pan brackets with the four latches. (Fig. 1) 5. Securely latch the pan to the machine by hooking the latch ring over the pan brackets and pressing down on each of the four latches until fully engaged. (Fig. 2) NOTE: For Safety, All four latches must be completely closed and secure before unit will turn on. The latch as shown above must also have the safety pin inserted. 6.
OPERATION INSTRUCTIONS 1. Press the power switch ON and allow the machine to run for 1-2 minutes. Note: If the machine begins to vibrate excessively, turn the Power Switch to OFF. Unplug the machine and make sure it’s on a level working surface. 2. Press the heating controller switch ON. Allow the machine to heat up for 4-5 minutes. 3. Empty one spoon of granulated sugar or cotton candy sugar mix into the floss head. CAUTION: THE FLOSS HEAD SPINS AT ULTRA-FAST SPEEDS AND IS HOT.
COTTON CANDY CART ASSEMBLY STEP 1: Remove the 6 preinstalled bolts (C) from the cross posts (F). STEP 2: Arrange leg post (D), U bar (E), and cross post (F). Cross post (F) should be attached to the hole furthest away from the black end cap on leg post (D). See Fig. 1 Fig. 1 STEP 3: Build the other side of the cart using leg post (D) and 2 cross posts (F) into the same shape as in Step 2.
STEP 7: Press on end-cap (h) to hide the bolts on outside of tire. See Fig. 3. Fig. 3 Fig. 4 STEP 8: Turn the frame upright. Remove the pan from the cotton candy machine. Set the cotton candy machine base on the posts, the power outlet should be between the wheels. Align the base to the bracket holes. Secure with 2 bolts (e). Repeat for the remaining posts. See Fig. 4 STEP 9: Hold the shelf (C) into place on the same side as the wheels. Secure using bolts (f).
CARE & MAINTENANCE CLEANING After your final batch of cotton candy in a session, keep the machine running and hot while cleaning the floss head by slowly pouring a small amount of water into the center. NOTE: The water will immediately become hot steam. Keep the floss head spinning through until water runs almost clear. Then, allow the machine to cool and dry with a damp cloth to remove excess sugar. The cotton candy pan may be cleaned with mild soap and a soft cloth. Do not use detergents.
TROUBLESHOOTING MACHINE HAS NO POWER Check to make sure that the bowl is seated correctly and all four latches are engaged and secure. If the safety switch is engaged and both switches are ON, unplug the machine and check the fuse; replace if defective. Contact us for further assistance if this does not resolve the problem. FLOSS HEAD WILL NOT SPIN, OR SMOKES Turn the power switch off, unplug the machine and clean the burnt sugar off with a soft cloth.
