User manual

6.10 LCD_CON 40pin connector

The LCD_CON pins are led out on a separate 40pin connecter for the ease of connecting an LCD.

We have tested the ability of the board to interact with such a display. They allow the user to attach

additional hardware, check readings or perform hardware debug.

Important: you need additional adapter board and two different 40PIN ribbon cables to connect an

Olimex display and the LCD_CON.

The LCD connector is suitable for a number of Olimex displays and touchscreen panels with

different native resolution – the smallest available is the 4.3'' one called LCD-OLinuXino-4.3TS

with native screen resolution of 480×272, through the 7'' one named LCD-OlinuXino-7TS with

800×480, to the 1024×600 10.1'' LCD-OLinuXino-10TS.

Full list of recommended displays for the board might be found in chapter “2.7 Connecting and

calibrating a display”.

Please note that the smallest display (4.3'', 480×272) is not suitable for the official Android images

we provide.

LCD_CON connector

GPIO pin# Signal name Processor pin GPIO pin# Signal name Processor pin

1 +5V -POWER CIRCUIT- 2 GND -POWER CIRCUIT-

3 +3.3V -POWER CIRCUIT- 4 GND -POWER CIRCUIT-

5 LCD_D16 Y12 6 LCD_D17 AA12

7 LCD_D18 Y11 8 LCD_D19 AA11

9 LCD_D20 Y10 10 LCD_D21 AA20

11 LCD_D22 AB12 12 LCD_D23 AC10

13 LCD_D8 AB11 14 LCD_D9 AC11

15 LCD_D10 Y15 16 LCD_D11 AA15

17 LCD_D12 Y14 18 LCD_D13 AA14

19 LCD_D14 Y13 20 LCD_D15 AA13

21 LCD_D0 AB15 22 LCD_D1 AC15

23 LCD_D2 AB14 24 LCD_D3 AC14

25 LCD_D4 AB13 26 LCD_D5 AC13

27 LCD_D6 AB12 28 LCD_D7 AC12

29 LCD_HSYNC AB9 30 LCD_VSYNC AC9

31 LCD_CLK Y9 32 LCD_DE AA9

33 PB3 B14 34 PB4 A13

35 LCD_PWR C4 36 PB2/PWM0 A14*

37 TPX1 Y22 38 TPX2 AA22

39 TPY1 Y23 40 TPY2 AA23

Signals marked with * are multiplexed with either a peripheral device or another connector. Ensure that the multiplexing is handled

properly on software and/or hardware level (else there would probably occur wrong levels, loss of data, etc).

Page 37 of 48