User manual

OLIMEX© 2013 MSP430-5510STK user's manual
CHAPTER 6: HARDWARE
6. Introduction to the chapter
In this chapter are presented the connectors that can be found on the board all together with their
pinout. Proto area is shown. Jumpers functions are described. Notes and info on specific peripherals
are presented. Notes regarding the interfaces are given.
6.1 Battery connector
The battery connector is used only to charge 3.7V Lithium batteries. It cannot be used to power the
board.
Pin # Signal name
1 VBAT
2 GND
6.2 JTAG connector
The 14 pin JTAG connector provides the interface for JTAG programming/debugging. The pinout
can be found in the table below.
JTAG connector
Pin # Signal name Pin # Signal name
1 TDO 8 TEST
2 P_IN 9 GND
3 TDI 10 Not connected
4 P_OUT 11 #RST
5 TMS 12 Not connected
6 Not connected 13 Not connected
7 TCK 14 Not connected
Page 12 of 24