User manual

2.3 Connecting to Arduino IDE

The latest Arduino IDE might be downloaded from the official Arduino web-site: http://arduino.cc.

After you have downloaded and installed (or extracted) the environment you should connect the

OLIMEXINO-328 to the computer via an USB type A to USB mini cable.

The first time you connect the board you would be asked for drivers. You can find the drivers

needed for OLIMEXINO-328 in the install folders of the Arduino IDE (usually in folder “drivers”).

After the drivers are successfully installed you should run the Arduino IDE.

In “Tools->Board” you should select “Arduino Duemilanove w/ ATmega328”.

That is all. Now you can load any built-in example or you can refer to the number of demo

examples in the “SOFTWARE” section of the OLIMEXINO-328's web-page:

https://www.olimex.com/Products/Duino/AVR/OLIMEXINO-328/

For more detailed instructions and Linux installation please check the following document:

https://www.olimex.com/Products/Duino/AVR/OLIMEXINO-328/resources/Install_OLIMEXINO-

328.pdf

Page 9 of 23