User manual

the programmer to your target board, you should first connect
the programmer to your computer and open MPLAB. There,
first from menu Configure – Select Device – choose the
microcontroller you are about to program, then from menu
Programmer – Select Programmer – choose MPLAB ICD 2, wait
while MPLAB is downloading operation system, and after ICD2
is connected – check in menu Programmer – Settings – Power –
there is option – Power target circuit from MPLAB ICD 2 – this
option should be forbidden, you could not select it. Now it is
safe to connect the programmer to your target board.
Software: MPLAB IDE and C18 C compiler
BOARD LAYOUT: