User manual

OLIMEX© 2013 STM32-H407 user's manual
4 PD1 14 PD11 4 PE1 14 PE11
5 PD2 15 PD12 5 PE2 15 PE12
6 PD3 16 PD13 6 PE3 16 PE13
7 PD4 17 PD14 7 PE4 17 PE14
8 PD5 18 PD15 8 PE5 18 PE15
9 PD6 19 +5V 9 PE6 19 +5V
10 PD7 20 GND 10 PE7 20 GND
PF PG
Pin #
Signal
Name
Pin # Signal Name Pin #
Signal
Name
Pin # Signal Name
1 +3.3V 11 PF8 1 +3.3V 11 PG8
2 GND 12 PF9 2 GND 12 PG9
3 PF0 13 PF10 3 PG0 13 PG10
4 PF1 14 PF11 4 PG1 14 PG11
5 PF2 15 PF12 5 PG2 15 PG12
6 PF3 16 PF13 6 PG3 16 PG13
7 PF4 17 PF14 7 PG4 17 PG14
8 PF5 18 PF15 8 PG5 18 PG15
9 PF6 19 +5V 9 PG6 19 +5V
10 PF7 20 GND 10 PG7 20 GND
6.8 PWR Jack
The power jack used is the typical 2.5mm one used by Olimex in most of our products. You should
provide between 6 and 16 volts @ 1A to the board.
Pin # Signal Name
1 Power Input
2 GND
More info about the power supply can be found in chapters 2 and 5 of this manual.
6.9 Battery connector
When using the battery connector keep in mind that it is an energy solution that wouldn't be able to
power the board and all the peripherals!
Page 18 of 28