User manual

OLIMEX© 2013 TMS320-XDS100v3 user's manual
*The entries NA means the standard signal was not routed (was not used for the JTAG connection).
It is important to keep signal 6 (TDIS by default) to GND, else the board won't detect the target.
A useful table for the relations of the signals might be found at the following web address:
http://processors.wiki.ti.com/index.php/JTAG_Connectors#Pinout
You might want to trace the above signal connection in the schematic that is located on the next
page. It show a tested and working adapter from 20-pin TI interface to a 20-pin ARM interface.
There is also a relative schematic of an adapter:
2.5 Powering the board and installation procedure for CCS 5
The XDS100v3 board is powered via the mini USB.
A. Install Code Composer Studio 5.1.x before connecting XDS100 USB hardware.
B. Install the EmuPack with XDS100v3 support. It is usually downloaded via the update button
Page 8 of 16