Operation Manual

per per

per

pepe

This cash register uses standard 2 1/4" (57 mm) paper. The paper

needs to be changed when a red line appears on the tape. You can use

either single-ply or dual-ply paper. Use dual-ply paper whenever you

want to print customer receipts and journal records, single-ply when

just customer receipts need to be printed.

Loading Single-Ply and Dual-Ply PLoading Single-Ply and Dual-Ply P

Loading Single-Ply and Dual-Ply P

perper

per

Proceed as follows to load the cash register with either single-ply or

dual-ply paper.

1. Make sure the cash register is plugged into a grounded power outlet

and that the control key is in the REG position.

2. Unlock, open and remove the printer compartment cover, then

remove the plastic journal winder spindle.

3. With a pair of scissors, cut the end of the paper tape to create a

straight, even edge so that the paper can be properly fed through the

print mechanism.

Re-inking the Re-inking the

Re-inking the

Thank Thank

Thank

ou Stampou Stamp

ou Stamp

Your cash register is equipped with a pre-inked rubber stamp that

automatically prints "YOUR RECEIPT THANK YOU" on every

receipt.

If the print becomes unclear or faint, you will need to re-ink the

stamp as follows:

1. Unlock, open and remove the printer compartment cover.

2. The Thank You stamp is located directly in front of the printer.

Grasp the stamp pad on both ends and pull upward.

3. On the reverse side of the stamp pad is a small hole. Feed one drop

of ink into the hole.

4. Replace the stamp pad. Be sure that it snaps into place securely.

5. Reposition, close and lock the printer compartment cover.