Operation Manual

13
ENGLISH
4. Set the paper roll in the bottom of the printer compartment so that
the paper feeds out from the bottom of the roll.
5. Insert the edge of the paper into the paper slot as shown in the
figure.
6. Press the [Feed] key and manually feed the paper into the slot until
the paper catches and advances approximately six to ten inches
above the print mechanism.
NOTE: If the paper does not feed properly, check the alignment of the
paper in the slot and/or for the straight edge on the end of the
paper roll.
7. If you are loading dual-ply paper for a journal record, slide the top
edge of the inner ply through the slots on the plastic journal winder
spindle and manually roll the winder toward the rear of the rear of
the cash register to take up slack in the tape. Make sure that the two
wheels on the spindle are positioned towards the right-hand side.
8. Replace the journal winder spindle in the printer compartment (the
two wheels must be positioned towards the right-hand side).
9. Pass the edge of the customer receipt (or the outer ply when using
dual-ply paper) through the receipt window on the compartment
cover.
10.Reposition, close and lock the printer compartment cover.