Operation Manual

ManualsBrandsOlivetti ManualsMiscellaneousECR2300

Setting Cash RegSetting Cash Reg

Setting Cash Reg

ister Fister F

ister F

eaea

turtur

tur

eses

All cash register features are programmed by first switching the

cash register into the program (PRG) mode by using the PRG key.

This chapter provides simple step-by-step procedures on how to

program the cash register. An example is provided after each procedure.

It is suggested that you first run through all the examples to become

familiar with the cash register's programming facilities, then program

the cash register according to your own specific needs.

NOTE: Program all the desired features at the same time in order to

create a single receipt of all selections. Keep the receipt in a

safe place for future reference.

Making Changes to Cash RegMaking Changes to Cash Reg

Making Changes to Cash Reg

ister Prister Pr

ister Pr

ogrammingogramming

ogramming

Once the cash register is programmed to satisfy your specific needs,

there is no need to reprogram the entire machine to make single

program changes or corrections. If you wish to make a change (such as

an update to VAT rates, PLUs or Euro exchange rates), be sure you are

in the program mode, re-do the program in question and finalize when

you are ready to exit the programming mode. A new program entry will

automatically overwrite a previous entry for the same program.

EnterEnter

Enter

ing the Pring the Pr

ing the Pr

ogram Modeogram Mode

ogram Mode

To enter into the program mode simply insert the PRG key into the

Control Lock and turn it to the PRG position.

Exiting the PrExiting the Pr

Exiting the Pr

ogram Modeogram Mode

ogram Mode

Proceed as follows to exit the program mode once you have finished

programming the cash register:

1. Print a Program Tape by pressing [999999] followed by the

[Amt Tend/TOTAL] key, as explained in the section entitled

Overall Programming Dump Report, for a printed report on how the

cash register is currently programmed.

2. Store the program tape in a safe place for future reference.

3. Turn the PRG key or REG key to the REG position if you wish to

carry out sales transactions, or to the OFF position if you wish to

exit.

ClearClear

Clear

ing Erring Err

ing Err

oror

To clear an error made during the programming phase, simply press

the [Clear] key. The error tone ends, the display clears and the keypad

unlocks.

In case an error condition cannot be cleared, perform one of the two

general clearance methods explained in the section entitled General

Clearance. Remember that the second general clearance sets all

counters and totals to zero, and cancels all features programmed.