Operation Manual

16
TO DELETE THE MESSAGE OR MEMO YOU ARE LISTENING TO
1. To start listening to the messages or memos, press the key:
The display shows:
PLAY MSG 01 03
30-03-04 10:47
2. To delete the message you are listening, press the key:
The TAD moves to the next message and the display shows:
PLAY MSG 01 02
30-03-04 10 :47
3. To delete the next message, press the key:
Proceed in the same way for all the messages you want to
delete.
note
If you do not want to delete any messages, press the key.
TO DELETE ALL MESSAGES ALREADY PLAYED
Let's suppose there are 6 messages on the TAD of which 3
have already been played back:
1. Press the key:
The display shows:
DELETE OLD MSG?
CANCEL/
2. To delete the messages you have already heard, press the
key:
The display shows the initial stand-by status and the number
of messages remaining after deletion. In this case, 3.
notE
If you do not want to delete any messages, press the key.
T O TRANSFER MESSAGES AND MEMOS TO A
REMOTE
TELEPHONE
If you wish, you can program the TAD to call you on a
remote telephone at a given time to let you know that
there are new messages on the telephone answering de-
vice.
In addition to the time and number at which you wish to be
called, you can program the way in which the transfer is
to be made (once only or once a day).
1. Press the key
until the display shows:
TAD SET-UP
2. To confirm the setting, press the key:
The display shows:
ICM ON SPEAKER
3. Press the key
until the display shows:
FORWARD MESSAGES
4. To confirm the setting, press the key:
The display shows:
FORWARDING OFF
5. To view the other two options available: "FORWARD.ONE
TIME" or "FORWARD. DAILY", press the keys:
/
6. To confirm your choice, press the key:
The display shows:
TYPE TIME
HH:MM
7. Type the time at which you want the messages to be trans-
ferred, for example: "11:45". To do this, press the keys:
-
8. To confirm the setting, press the key:
The display shows:
TYPE TEL. NUMBER
9. Type the telephone number where you want to be called,
for example: "02 614456". To do this, press the keys:
-
10. To confirm the setting, press the key:
The display shows:
REC.FORW.ANNOUNC
At this point, you may proceed to record the transfer mes-
sage (see "To record the transfer message") or abort
the procedure by pressing the
key.
note
The message transfer setting is cancelled by a power failure.