Operation Manual

21
4. Press the key
until the display shows:
RING VOLUME:HIGH
5. To view the other available options, "RING VOLUME:LOW",
"RING VOLUME: MED" and "RING VOLUME:OFF", press
the keys:
/
6. To confirm your choice, press the key:
7. To return the fax machine to its initial stand-by mode, press
the key:
TO ENABLE/DISABLE RECOGNITION OF THE RING
FREQUENCY
In some countries, local telephone companies offer the pos-
sibility of assigning the same telephone line two or
more numbers, corresponding to different users. When
an incoming call is received, a different ring frequency
will indicate which user is to answer the call.
This function is extremely useful at home or in small offices,
where the same telephone line is shared by more than one
person.
Your fax machine is capable of "learning" one of
these frequencies (see the procedure that follows). In
this way, when a call with the specific ring frequency is
received, the fax machine (in "PHONE/FAX" and "TAD/
FAX" reception modes) prepares exclusively to receive a
document.
This function is particularly useful when associated
with silent reception in that the fax machine will only ring
if the call is coming from a telephone.
1. Press the key
until the display shows:
INSTALLATION
2. Press the key:
The display shows:
TEL. LINE SET-UP
3. Press the key:
The display shows:
ENHANCED FEATUR.
4. Press the key
until the display shows:
DISTINC.RING:OFF
5. Press the keys
/ until the display shows:
CHANGE PATTERN
6. To confirm your choice, press the key:
The display shows:
AUTODETECT. RING
7. Call the fax machine with the desired frequency so that the
fax machine detects it.
The display shows:
RING DETECTED
8. To return the fax machine to its initial stand-by mode, press
the key:
notE
If the fax machine cannot detect that particular frequency, the display
will show the message "RING NOT DETECT.". At this point, press
the
key and repeat the procedure.
TO CHANGE THE LENGTH OF THE ACOUSTIC SIGNAL
This function is only enabled in some countries.
When the fax machine is set up for automatic reception
with recognition of the type of call, it behaves as
follows:
• if it is being called by a fax machine, it will automatically
prepare to receive a document after the preset number of
rings
• if it is being called by a telephone, it will emit an acoustic
signal for a time of 20 seconds, after which, if you still have
not lifted the handset, it will automatically prepare to re-
ceive a document.
If you want, you can change the length of the acoustic signal
as follows:
1. Press the key
until the display shows:
INSTALLATION
2. Press the key
until the display shows:
FAX/TEL TIMER:20
3. To view the other available values, "15", "30" or "40",
press the keys:
/
4. To confirm your choice, press the key:
5. To return the fax machine to its initial stand-by mode, press
the key: