Operation Manual

109
SIGNALS AND SERVICE CODES
MESSAGES ON THE DISPLAY
MESSAGE SOLUTION
TOP OPEN Close the lid of the operator console.
REM. DOCUMENT Remove the document and replace it correctly in
the feed slot.
NO INK With a disposable print head, replace the head.
With a print head with an interchangeable ink cartridge,
replace the cartridge.
If the message persists, replace the print head. See the
"MAINTENANCE" chapter.
CHECK PAPER Add paper to the cassette and check the position of
the paper positioning lever.
NO HEAD Insert the print cartridge. If the message appears even
when the cartridge is present in the facsimile machine, it
has proprobably been inserted incorrectly. In this case,
remove and reinsert the cartridge.
If the message persists, clean the electrical contacts (see
the “Cleaning the electrical contacts” section of the
“MAINTENANCE” chapter.
HEAD NEW? This message appears on the display after the print
YES = CONF. NO = CLEAR cartridge has been inserted. If the cartridge is new, select
YES by pressing SET/CONF. ; if it is not, select NO by
pressing CLEAR.
WARNING: If you select YES and the cartridge is not
new, the no ink left status will not be detected.
CHECK NOZZLES Follow the print head nozzle purging procedure.
Should faults be found, act according to the diagnostic
result printed (see the “Checking the print head nozzles”
section of the “MAINTENANCE” chapter).
If the message persists, replace the print cartridge.
HANDSET OFF HOOK Place the handset on the hook.
OPERATION INTERR This message appears on the display for a few seconds
when you interrupt a procedure in progress.
NO DOCUMENT Insert the document in the ADF.
DIAGNOSTIC ON When powered on, the facsimile machine runs a short
test on its components and then gets ready for operation.
At the end of the procedure, check that the facsimile
machine is in stand-by.
cap16.p65 13/04/00, 23.07109