Operation Manual

27
PROGRAMMING
CLEARING PROGRAMMED DATA
If you like, you can clear the data programmed under one-touch dialling keys or speed dialling codes.
This section describes the data clearing procedure in relation to the storing procedures described in the
previous two sections.
o The facsimile machine is on. There is no document in the ADF. One-touch dialling keys and speed dialling
codes have been programmed.
1 - T O U C H D I A L I N G
1 : 0 0 3 4 2 2 4 5 7 7 3 0
1. Follow the procedure described in steps 1 to 3 of the
“PROGRAMMING ONE-TOUCH DIALLING KEYS”
section or the procedure described in steps 1 to 4 of
the “PROGRAMMING SPEED DIALLING CODES”
section.
Example: follow the procedure described in steps 1
to 3 of the “PROGRAMMING ONE-TOUCH DIALLING
KEYS” section.
2. Press
∨∨ or ∧∧ to select the one-touch dialling key or
speed dialling code that you want to select.
Example: select the one-touch dialling key 3.
3. Press CLEAR . All the data set for the one-touch
dialling key selected is cleared.
The facsimile machine then immediately displays the
next one-touch dialling key after the cleared one: in
the example given in the manual, the one-touch
dialling key “4”.
4. Repeat steps 2 and 3 to clear the data for the next key,
or press STOP twice to quit the menu.
1 - T O U C H D I A L I N G
3 : 0 0 3 4 2 2 5 6 7 8 9 0
1 - T O U C H D I A L I N G
4 : 0 1 1 2 3 4 7 8 8
PRINTING PROGRAMMED DATA
You can print out the data programmed under the 16 one-touch dialling keys and the 32 speed dialling codes.
In this way, you can keep track of all the numbers stored (fax and telephone) and the data entered for each key
or code, checking the keys or codes that have been programmed and those that have not.
cap05.p65 13/04/00, 22.1727