Installation Manual


Page 7

Step 3: Drill wall hole for connective piping
1.
Determine the location of the wall hole based
on the position of the mounting plate. Refer
to Mounting Plate Dimensions.
all
0.2-0.275in
(5-7 mm)
MOUNTING PLATE DIMENSIONS
Different models have different mounting plates.
For the different customization requirements, the
shape of the mounting plate may be slightly
different. But the installation dimensions are the
same for the same size of indoor unit.
See Type A and Type B for example:
2. Using a 2.5in (65mm) or 3.54in (90mm)
(depending on models) core drill, drill a
hole in the wall. Make sure that the hole
is drilled at a slight downward angle, so
that the outdoor end of the hole is lower
than the indoor end by about 0.2-0.275in
(5mm-7mm). This will ensure proper water
drainage.
3. Place the protective wall cuff in the hole. This
protects the edges of the hole and will help
seal it when you finish the installation process.
CAUTION
When drilling the wall hole, make sure to
avoid wires, plumbing, and other sensitive
components.
NOTE: When the gas side connective pipe is
Ø5/8in (16mm) or more, the wall hole should
be 3.54in (90mm).
Type A
Type B
Left rear wall
hole 2.5in (65mm)
Right rear wall
hole 2.5in (65mm)
Right rear wall
hole 2.5in (65mm)
Right rear wall
hole 2.5in (65mm)
outline
1.5in (39mm)
1.5in (39mm)
1.5in
(39mm)
11.2in (285mm)
11.2in (285mm)
1.85in
(47mm)
1.5in
(39mm)
1.4in
(36mm)
1.4in (36mm)
1.85in
(47mm)
1.85in
(47mm)
1.85in
(47mm)
1.85in
(47mm)
1.85in (47mm)
1.85in (47mm)
1.85in (47mm)
Model B
Model A
5.8in(148mm)
9.1in(230mm)
9.7in(246mm)
1.7in(45mm)
1.7in(45mm)
1.7in(45mm)
4.1in(103mm)
7.3in(185mm)
28in(715mm)
31.7in(805mm)
4.2in(107mm)
4.2in(107mm)
5.1in(130mm)
5.5in(139mm)
9.3in(237mm)
15.8in(402mm)
16.2in(411mm)
outline
11.88in (302mm)
Model C
Model D
285mm(11.2in)
9.57in(243mm)
9.5in(240mm)
5.6in(143mm)
3.9in(100mm)
37.7in(958.3mm)
12.79in (324.9mm)
(55mm)
2.16in
(55mm)
2.16in
10.4in(264mm)
40.85in(1037.6mm)
219mm(8.6in)
13.5in(344mm)
299mm(11.8in)
1.77in(45mm) 1.77in(45mm)
Left rear wall
hole 2.5in (65mm)
Left rear wall
hole 2.5in (65mm)
Left rear wall
hole 2.5in (65mm) hole 2.5in (65mm)
Right rear wall
outline
18in(458mm)
22in(559mm)