Use and Care Manual

ManualsBrandsOlympia Water Systems ManualsKitchenBooster Pump Under-Sink Reverse Osmosis Water Filtration System with 50 GPD RO Membrane - for Low Water Pressure

Maintenance

Maintenance Schedule

This RO system was designed to ensure ease of use and low maintenance. If the lters are

changed regularly as suggested below and is run within the suggested ouput capacity, the RO

system should work properly for many years.

To assist with maintaining proper care of the RO system, use the System Service Schedule on

page 17 to keep track of completed maintenace on the RO system.

Important!

It is important to change the lters for stages 1, 2 and 3 at least every 6-12 months. The rst 3 lters protect the RO mem-

brane. If the lters are not changed, the membrane will be damaged and the RO system will be contaminated.

Replace every 6-12 Months

If water source is from a private well or water source with high

levels of heavy sediments; lter may need to be changed sooner.

Stage-1

Sediment Filter

Replace every 6-12 Months

If water source is from a private well or water source with high

levels of heavy sediments; lter may need to be changed sooner.

Stage-2 and Stage-3

Carbon Filter

Replace every 2-3 Years

Dependent on proper maintenance of stages 1-3 and level of

water usage.

Stage-4

RO Membrane

Replace every 2,500 Gallons (9,500 Liters)

Usually replaced at the same time as the RO membrane.

Stage-5

Post Carbon Filter

Replacement Filters

Olympia Water Systems oers replacement lters for both the OROS-50 and OROS-80 Re-

verse Osmosis water ltration systems. For purchasing information for replacement lters,

please visit our website at www.olympialtration.com.

Summary of content (5 pages)

PAGE 1
Maintenance Maintenance Schedule This RO system was designed to ensure ease of use and low maintenance. If the filters are changed regularly as suggested below and is run within the suggested ouput capacity, the RO system should work properly for many years. To assist with maintaining proper care of the RO system, use the System Service Schedule on page 17 to keep track of completed maintenace on the RO system.
PAGE 2
Filter Replacement I. Turn off Cold Water & Tank Valve: Turn cold water supply and tank ball valve to OFF positions. Turn system faucet to the ON position to release any built up pressure in the RO system. Once pressure has been released, turn system faucet to OFF position. II. Open Housings: See Fig. 19. Starting with the 1st stage, use the large provided wrench remove the filter housings one at a time by turning counter-clockwise. III.
PAGE 3
RO Membrane Replacement I. Turn off Cold Water & Tank Valve: Turn cold water supply and tank ball valve to OFF positions. Turn system faucet to the ON position to release any built up pressure in the RO system. Once pressure has been released, turn system faucet to OFF position. II. Remove Tubing from Housing: See Fig. 22. Remove BLUE tubing lock clip and remove the tubing from the cap of the RO housing on the main system bracket.
PAGE 4
Post Filter Replacement It is recommended to replace the post carbon filter at the same time the RO membrane is replaced. I. Turn off Cold Water & Tank Valve: Turn cold water supply and tank ball valve to OFF positions. Turn system faucet to the ON position to release any built up pressure in the RO system. Once pressure has been released, turn system faucet to OFF position. II. Remove Tubing & Filter: See Fig. 25.
PAGE 5
System Service Record Date of Purchase: Date 1st Stage Sediment Date of Install: 2nd Stage Carbon 3rd Stage Carbon Notes: 17 Installed By: RO Membrane Post-Filter Carbon