User manual

15
Cold Laminating
1 Connect the power cable to an easily accessible, standard electrical
socket.
Caution: Check that the voltage specifications of the unit correspond
to that of your power supply network (220 - 240 V, 50 Hz).
2 Switch on the On/Off switch on the top, right-hand side of the unit
(I).
3 The drive motor for the transport rollers starts up, the red and yellow
indicator lamps (POWER and READY, respectively) light up.
Caution: If the laminator was switched to hot laminating shortly before,
allow it to cool down. The equipment takes about 30 minutes to cool down.
4 Remove the protective foil from the pouch.
5 Insert the document to be laminated in the pouch so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
6 Insert the foil containing the document in the laminator's insertion slot.
Insert the ready closed side of the foil first.
Note: To prevent the laminating foil from creasing, never insert the
open end of the pouch in the insertion slot of the laminator first. When insert-
ing the foil, observe the instructions on the insertion slot. The laminating
process occurs automatically.
Clearing Foil Jams
The laminator is provided with a "Jam Release" function in order to clear foil
jams quickly.
1 If the foil jams, switch the equipment off and set the switch on the left
side of the unit to its "Jam Release" position.
2 Hold the laminator firmly and pull the foil together with the document to
be laminated out of the laminator's insertion slot.
3 Set the switch on the left side of the unit to its "Normal Operation" po-
sition.
4 It will probably be necessary to then clean the unit several times as
described in the Section "Cleaning and Servicing".
5 If foil jams occur repeatedly or jammed foil cannot be removed from
the laminator, please contact our hotline.