Instructions / Assembly

Page 5
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note: Unless stated otherwise, all connections are
made using Bolts, Washers and Nuts (B). Finger tighten
all connections until assembly is done. Assemble
the Workbench on a flat, level, hard surface.
1. Attach Side Beams (4) to Front
(1) and Back Posts (2).
2. Attach Rubber Feet (3) to the bottom
of all 4 posts. (See Figure A.)
1
2
4
3
3
1
2
3
3
4
Figure A
3. Attach Bottom Beams (5) to the Front (1)
and Back (2) Posts. (See Figure B.)
5
5
2
2
1
1
Figure B
4. Attach Side Beam (4) and Side Beam with Power
Strip Opening (4A) to the top 2 holes on Front Posts
(1) and the middle 2 holes on Back Posts (2).
Note: Side Beam with Power Strip Opening can
be attached to either the right or left side.
5. Attach Power Strip (22) to Side Beam with
Power Strip Opening using U Brackets
(F) and Screws (E). (See Figure C.)
4
4A
22
E
F
E
E
E
2
2
1
1
Figure C
6. Attach Top Beams (6) to the top 2 holes
on Front Posts (1) and the middle 2 holes
on Back Posts. (See Figure D.)
Note: Make sure the Front Top Beam (6) carries
the Warning Label and is right-side up.
6
6
Warning
Label
1
2
2
1
Figure D