Full Product Manual

OLYMPIA TOOLS INTERNATIONAL, INC.
Tel. [phone] / Fax. [phone] / Web. www.olympiatools.com
Page 6
Your machine is equipped with a ground fault circuit interrupter (GFCI), which protects you against shock if a short circuit
should occur. Check that the receptacle is properly grounded and test the GFCI before each use.
1. Plug the GFCI Power Plug into a Grounded.
2. Press the TEST button. The GFCI indicator light will go out and power to the machine should cut off.
3. WARNING! If the light does not go out when test button is pushed, equipment should not be used until
proper repairs can be made.
4. To restore power after test, push the reset button. WARNING! If the machine doesn’t start, stops while running,
or if you experience a mild shock, do not use the machine. Have it repaired or replaced by a licensed electrician.
Note: The Power Cord is not GFCI protected from the GFCI unit to the 3-prong plug in the electrical outlet.
Ground Fault Circuit Interrupter(GFCI)
1. Grounded tools require a three wire extension cord. Double Insulated tools can use either a two
or three wire extension cord.
2. As the distance from the supply outlet increases, you must use a heavier gauge extension cord.
Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in a loss of power and
possible tool damage. (See Table A.)
3. The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry
a higher current than a 16 gauge cord. (See Table A.)
4. When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum
wire size required. (See Table A.)
5. If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine
the required minimum cord size. (See Table A.)
6. If you are using an extension cord outdoors, make sure it is acceptable for outdoor use.
7. Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension
cord or have it repaired by a qualified electrician before using it.
8. Protect the extension cords from sharp objects, excessive heat, and damp or wet areas.
Extension Cords
RECOMMENDED MINIMUM WIRE GAUGEFOR EXTENSION CORDS* (120/240VOLT)
NAMEPLATE AMPERES
(at full load)
EXTENSION CORD LENGTH
25
＇
50
＇
75
＇
100
＇
150
＇
0-2.0
18
18
18
18
16
2.1 -3.4 18 18 18 16 14
3.5 -5.0 18 18 16 14 12
5.1 -7.0 18 16 14 12 12
7.1 -12.0 18 14 12 10 -
12.1 -16.0 14 12 10 - -
16.1 -20.0
12
10
-
-
-
*
Based on limiting the line Voltage drop to five volts at150% of the rated
TABLE A armperes