Operation Manual

21
Troubleshooting
Fault Corrective measures
• The LED strip does not light up
• Device does not respond
• Check that the power switch on
the rear side of the device has
been switched on. Also check that
the On/Off switch on the operating
panel has been switched on.
• If the fault cannot be cleared,
please contact the sales outlet
where you purchased the device
(refer to Guarantee).
• Foil jam • Check the foil pockets being used
are the correct size.
• Only use foil pockets of the size
specified.
• Ensure that the foil pocket is
straight when inserted in the de-
vice.
• To clear the fault, follow the in-
structions in the Section "Clearing
Foil Jams".
• Laminated foil is not completely
transparent
• Laminate the same foil again to
improve the lamination result.
Conformity of the equipment to the
EU directives is confirmed by the
CE mark.