Specifications

８
Select the Count Mode.
This model machine can work in two ways – In ‘Free Count’ mode and
‘Batch
Count’ mode. The Count mode can be selected by setting the batch
number.
- Free Count Mode.
In this mode, the machine counts all notes in the Hopper without stopping.
This
count mode will be set in case the 'blank' is selected on the Batch
Number Display by pressing the “C” Key.
- Batch Count Mode.
In this mode, the machine counts out a batch of notes that you have preset.
This
Count mode will be set by selecting a desired number on the Batch
Number Display. Before beginning the count, turn off the “code” key and
used the number Key Pad to set the desired number, and then begin
counting normally.
Notes
: The next count session will be started automatically when you
remove the counted batch of notes from the Stacker.
If the counting stops in the case when the preset number has not been
reached, whilst all the notes have been counted, just refill the Hopper. The
machine will continue counting automatically.
ADDition counting function.
Under the ADDition function, the accumulative total is shown on the
Counting
Number Display. Press the ADD Key to select this function with
the ADDition indicator lit.
To clear this function, press the ADD Key once again. This clears the ADD
indicator.
Setting the Thickness Adjustment Screw.
The Thickness adjustment Screw is set at the default position by the factory.
However, it must be slowly and carefully adjusted
in the following manner.
Large movements should not be necessary:-