Operation Manual

Page 63
OLYMPIA CM 1856F _______________________Programming Instruction___________________________________
13. SERVICE-PROGRAMM im „S“ MODE
START Program with: 1. Plug out the Mains plug
2. Set the key position on the cash register to “S“
3. Plug in the Mains plug
4. Scroll with the Keys
[3DJH8S] and
[5(&(,37212))]
Back with
[=:] Key.
Screen display in service mode: LOAD FLASH MEMORY
FACTORY TEST
EXIBITION
1. LOAD FLASH MEMORY : Starts the menu for transferring the PC software
2. FACTORY TEST : Starts the menu test programme
3. EXIBITION : Starts a display test, to end this pull the mains cable.
With the keys
[3$*(83] and [5(&(,372Q2))]
go to LOAD FLASH MEMORY and confirm with the
[&$6+] Key.
Display : HISTORY
OPEN PORTS FOR PC
RUN FLASH PROGRAM
1. HISTORY : All system data of the cash register is shown
2. OPEN PORTS FOR PC : In this menu, new software programme updates can be send to the cash register.
3. RUN FLASH PROGRAM : Starts a test and jumps to the programming S-MODE.
With the Keys
[3$*(83] and [5(&(,372Q2))]
go to FACTORY TEST and confirm with the
[&$6+] Key.
Display Anzeige: ALL TEST ( with printing ) SELF-TEST-function
SELECTED ( without printing ) SELF-TEST-function
With the Keys
[3$*(83] and [5(&(,372Q2))]
go to EXIBITION and confirm with the
[&$6+] Key.
Display : A display test with demo programme runs automatically. Only end this by pulling the mains cable.
To end the S-Mode: Pull the mains cable, set the
cash register to OFF or REG and plug the mains cable back in
.