Quick Start Guide

ManualsBrandsOlympia ManualsMiscellaneousCM 726 plus

Quick Reference CM 721/726 PLUS Cash Register (13)

Olympia 09.2001 Page 1 Rights to make technical changes reserved!

This Quick Reference manual only provides basic information.

More detailed information is available in the Operating Instructions.

Insert paper roll

Raise the printer lid as illustrated. Use paper rolls with a width of 57mm and maximum diameter of 70mm. Do not use

recycled paper. This causes quicker printer wear. Prepare the paper roll for insertion. Remove the first layer and cut the

end of the roll straight. This prevents paper jamming in the printer mechanism. Insert the cut end of the roll in the printer

and press

until approx. 10 cm has been fed in. Depending on the method of use, feed the paper past the tear-off

edge on the printer lid or onto the take-up reel. Finally, close the printer lid.

Paper reel

The paper reel is required when the journal paper (special two-layered paper roll with carbon copy facility is required) or

the receipt paper should be rolled onto it.

1. Open the printer lid.

2. Remove the paper reel.

3. Thread the end of the journal paper in the slit in the paper reel.

4. Insert the paper reel in the hollows provided for it.

5. In order to remove the journal paper after it has been rolled up on the reel, remove

the paper reel and pull the journal paper roll off.

6. Reinsert the paper reel.

7. Close the printer lid.

Change ink roller

Note: Only use original ink rollers.

1. Open the printer lid.

2. Pull the ink roller up and out using the grip (on the left).

3. Insert a new ink roller on the guides.

4. Close the printer lid.

Key-operated switch

The key must be set to position REG for normal operation (registration).

Off Registration

(normal

operation)

X-reports

(without memory

deletion)

Z-reports (with

memory

deletion)

Programming

Calculation Training

Password

Flag 28

Note: Loss of data and jamming of the cash register are possible in operating of Z or P modes! Only use these

modes when you are familiar with programming and operating the machine.

Summary of content (8 pages)

PAGE 1
Quick Reference CM 721/726 PLUS Cash Register (13) This Quick Reference manual only provides basic information. More detailed information is available in the Operating Instructions. Insert paper roll A Raise the printer lid as illustrated. Use paper rolls with a width of 57mm and maximum diameter of 70mm. Do not use recycled paper. This causes quicker printer wear. Prepare the paper roll for insertion. Remove the first layer and cut the end of the roll straight.
PAGE 2
Quick Reference J CM 721/726 PLUS Cash Register Clearing errors Incorrect input or error status (acoustic signal) can be cleared by pressing the ! Registration according to department (13) key. Enter price without decimal point (max. 7 digits). Price Department PPPPPPP Or: if the same item should be registered several times: K No. of items NNNN ! Price PPPPPPP Department The sum of NNNN x PPPPPPPP is limited to the maximum capacity of the cash register. F K 7.
PAGE 3
Quick Reference CM 721/726 PLUS Cash Register (13) Abbreviations Normal operation (registration) CA Cash * Payment by credit-card CK Payment by check CH Payment by charge RA Payment received on account PO Paid out NT Net total ST Subtotal AT1-4 Amount is specified currency CG Change TX1-4 Tax contained according to tax rates 1-4 TA Amount taxed RF Total of refunds %+ Premium percentage %Discount percentage Discount, variable Coupon *VD Void or error correct NS No sale, drawer opened @ Item price TX1-4 Ta
PAGE 4
Quick Reference CM 721/726 PLUS Cash Register (13) Programming Flags BR 4B .707 NP The basic cash register program is stored in Flags. Print Flags: The programs can be printed. Program Flags: e.g. Flag 07, time E.g.
PAGE 5
Quick Reference CM 721/726 PLUS Cash Register FLAG 14 Z-report layout 1 0 0 = Recommended setting 0 = Grand Total is not printed, receipt no. reset 1 = Grand Total is printed, receipt no. reset 2 = Grand Total is not printed, receipt no. not reset 3 = Grand Total is printed, receipt no. not reset.
PAGE 6
Quick Reference CM 721/726 PLUS Cash Register FLAG 33 Setting Canadian tax system 0 0 0 = Recommended setting 0 = Setting non-taxable limit without GST TAX for Canadian tax mode 1 = Setting non-taxable limit with GST TAX for Canadian tax mode 0 = Do not select the Canadian taxation system of TAX ON TAX 1 = Select the Canadian taxation system of TAX ON TAX 0 = Include GST in PST1/PST2/PST3 1 = Do not include GST in PST1 2 = Do not include GST in PST2 3 = Do not include GST in PST1/PST2 4 = Do not include G
PAGE 7
Quick Reference CM 721/726 PLUS Cash Register (13) Programming currency conversion Refer to the Operating Instructions for more detailed information. Euro in the period 01.01.2002 – 28.02.2002 During this period, all of conversions are based on the Euro currency (1) which must be programmed under Flag 34. Local currency = Euro The currencies (FCE keys) must be programmed as follows: Á± °°°°°°°°° Á² °°°°°°°°° Á³ °°°°°°°°° Á´ °°°°°°°°° T 72/.62250 N72/.62250 N72/.
PAGE 8
Quick Reference CM 721/726 PLUS Cash Register (13) Caution: Only carry out the following entries when you are familiar with programming process! Caution: Set the key to position PRG D /012 D 0123 D 1234 D 1735 T After pressing the following key combination, the grand total is deleted. It can only be performed when all Z-reports have been printed out beforehand. .