Operation Manual

Cash Register CM 910 / 911 / 912
Olympia
2011 Page 39 Specifications subject to change without notice!
- Continued -
Input Display
● Use the  and  keys to
move to the input area Native:
#
Native: 0
● Enter the local currency.
#
Native: 1
● Confirm by pressing CASH.
3#
Native: 1
● Conclude programming by
pressing the SUB-TOTAL key.
2#
5.16 Programming tax rates
A maximum of 4 tax rates can be programmed.
Note: When the machine leaves the factory, VAR rate 1 is already pre-programmed to 19% and VAT rate 2 to 7%.
If these rates correspond with those you need, no adjustments to the programme are necessary at this point.
Example: VAT rate 3 should be 6% (number of decimal places: 2 (default setting)).
Input Display
=TAX GROUP 1- 1=
● Set the key to PRG
● Select programme number 30
(refer to Chapter 5.1.2).
● Confirm by pressing CASH.
3
19.00 RATE%
=TAX GROUP 3- 1=
● Press the CASH key to
change to another tax memory
location.
3#
0.00 RATE%
● Use the  and  keys to
move to the input area
[ ] RATE%.
#
● Use the digit keys to enter the
tax rate (with decimal point and
decimal places).

#
6.00 RATE%
● Confirm by pressing CASH.
3#
6.00 RATE%
● Conclude programming by
pressing the SUB-TOTAL key.
2#
Note: When programming the departments, the tax rate is assigned to the departments. The tax totals are only
calculated and printed on the receipt when the tax rate is actually assigned to the departments.