Operation Manual

Cash Register CM 910 / 911 / 912
Olympia
2011 Page 41 Specifications subject to change without notice!
5.18 Programming the end lines
The end lines on the receipt can contain up to 3 lines and a maximum of 32 characters per line.
Three end lines are already pre-programmed.
Note: If you do not want to print end lines, you can delete the pre-programmed end lines.
Note: Refer to Chapter 5.2 for information on entering text.
Note: Text lines which are not programmed are not printed.
End lines are programmed analogue to programming logo messages. The only difference is that program number 32
must be selected in the program menu.
Input Display
=AD MEASSAGE - 1=
********************************
THANK
********************************
● Set the key to PRG
● Select programme number 32
(refer to Chapter 5.1.2).
● Confirm by pressing CASH.
The programmed end lines appear
in the display. The end line is
already selected.
3
#
For further procedure, refer to Chapter 5.17.
5.19 Selecting a graphical logo
You can print a graphical logo above the logo message on a receipt.
There are 23 motifs available for selection, refer to Figure 1 (next page).
Input Display
=GRAPHIC LOGO - 1=
● Set the key to PRG
● Select programme number 44
(refer to Chapter 5.1.2).
● Confirm by pressing CASH.
When the machine leaves the
factory, a 0 is set in the input area,
i.e. no graphical logo is printed.
3
#
[ 0] STATUS
● Enter the number of the
graphical logo you want to print
in the input area, e.g. 17.
● Confirm by pressing CASH.
3
#
● Conclude programming by
pressing the SUB-TOTAL key.
2#